Stainless Steel Flue Liner 316L Grade 150mm / 6"

10 year warranty (conditions apply). A double skinned 316L Grade flexible flue liner suitable for relining within a masonry chimney. Flue liner is suitable for use with gas, oil, coal, coke, cured dry logs, cured dry peat. 904 grade flue liner is recommended for Smokeless fuel
Stainless Steel Flue Liner 316L Grade 150mm / 6" is available to buy in increments of 1

Delivery: normally within 3 working days.  Next day possible if ordered before 12 (T & C's apply).  more about delivery

For more info call 01244 913 320 or email us 

Free  flue design service  - we aim to beat any quote for similar products.


The 316 flue liner is constructed from a single strip of 316L grade steel which is bent at 180 degrees and then folded in four planes to give the "quattrolock" seal. The flue liner is approved and listed by HETAS FLUE LINER INSTALLATION:

Flue Liner should always be fitted from the top. Make sure the arrows are pointing upwards (gas flow).

1.Have the chimney swept and checked professionally to see if a liner is required.

2. Make sure the liner will go down the chimney e.g. by pulling down a 1 metre section of the liner you will be using.

3.Check your chimney pot is in good condition, if you are NOT using a suspended chimney pot cowl then remove the pot from the stack.

4. Secure a length of rope longer than the Flue Liner to the Nose Cone (ordered separately as part of a fitting kit).

5. Attach the Nose Cone onto the end of the Flue Liner, making sure the arrows on the Flue Liner are pointing away from the Nose Cone in an upward direction so when the liner is installed the arrows will be pointing UP to the top of the chimney.

6. Pull the liner down the chimney using the rope and at the same time have someone at the top of the chimney pushing the Flue Liner down.

MAINTENANCE: Chimneys serving solid fuel appliances should be checked every 6 months and swept at least once a year.

**please measure carefully before ordering as the flue liner is cut to size, and therefore, non-refundable.

More Information
Inner Material 316L - 0.12mm thick
Outer material 316L - 0.12mm thick
Certification EN1856-2 T450 N1 D V3 L50012 G
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account