45 Degree Short Angle / Matt Grey
European type heavy gauge steel pipe with matt grey painted finish.
200mm Approx. overall length.
Robust construction of 2mm thick Steel, Type EN 10025
The Long sides are approx. 150mm long
If two are joined for an offset flue, the offset will be 120mm approx.
One short and one long angle will be 185mm approx.
Air tight flush fitting joints (N1 / 40 Pa).
For solid fuel appliances tested to temperatures up to 500 degrees C.
Used to connect the stove and Flue Liner / Chimney Stack / Twin Wall Flue System.
CANNOT be used to pass through ceilings or walls, or outdoors.
Distance to combustible materials (including fire rated plaster board): 500 mm minimum (or UK regs state > 3 times the diameter of the flue,
150mm diameter Flue Pipe should be 450mm away from combustible materials.
The smaller spigot end should be pointing downward to allow water to flow within the pipe.
Joints can be sealed with a fine jointing compound if desired (flueseal or ceramix - fire cement is too coarse). Joins between the flue pipe and stove, and between the flue pipe and twin wall chimney or flue liner, will need to be sealed and may require a fire proof glass rope also.
Inspect the chimney at least every 6 months and clean every 12 months, more often when using coal.
Use a pipe with an access door, or clean from within the stove when possible.
|CE Rating||EN 1856-2-T400-N1-D-VmL01200-G500|
|Wall Thickness||2 mm|
|Type (EU / UK)||European|